If you don’t already have a personal pressure washer for your home, we recommend Ex-Cell pressure washers for sale at Home Depot. When cleaning a frame for a car, you are restoring the Ex-Cell pressure washer is perfect. To clean the frame properly and remove grease, oil flaking paint, cob cloths and debris, we suggest the 15 degree tip for maximum power.
It would be best to have the following supplies available; Heavy and Light Liquid Degreaser, we recommend some Plastic sheets that are used in painting and for the protection of your body; goggles that protect your eyes, rain gear, and plastic boots.
When hitting areas where the frame meets or where there are holes in the frame, which have paint or rust particles on them, you will want to hit them with the zero point. Be careful to wear eye protection because the diverted water will keep moving very fast. Water not diverted if it hits your body can easily break the skin.
Better to work on one section at a time. It is also important to contain the flow of dirty water once you start using the cleaning chemicals. You will often be surprised how well your pressure washer works without degreaser or with a light degreaser. To get this job done right, follow this simple step-by-step guide. First check the water flow to make sure dirty water does not enter the gutter, then put the plastic in the section to be cleaned and use two by four to place under the outer edges of the plastic to stop the flow of water. Rinse the area to be cleaned before you begin, then spray on stubborn and stubborn stains and paint chips a short distance and rinse to see how good it looks.
If it looks good, you are done; if not, continue with the next set of steps. Spray degreaser on areas to remove hardened grease and oil. Allow about 30 seconds dwell time for it to penetrate and then explode at close range with a 15 degree tip and a zero tip if necessary. Rinse with the wide angle tip and repeat until satisfied and continue this process in other sections.